Optical Fibre and Copper Cabling Systems

Data Rack Ducting & Accessories

Showing all Data Rack Ducting & Accessories

DATA RACK, FRONT TO BACK DUCT FOR FIBRE CORDS, WITH TRUMPET OUTLETS

Part Number: TC1279-750KIT

This kit is installed from the front to the rear of a data rack, allowing fibre cords to be fed from front to back of the rack. The duct is supported by two sturdy metal mounting brackets fitted to the front and rear equipment mounting rails on either the left or right hand side; (4 x mounting screws and cage nuts are supplied). This kit occupies 2 RU of mounting space. The mounting brackets hold duct securing (“C”) brackets, which have 65mm of lateral adjustment. A length of 100mm x 50 mm duct carries the cords. It is supplied as a length of 800mm, which can be trimmed to suit the depth of the data rack. One end of the duct is slotted to accept a trumpet secured by a standard joiner. The other, (non-slotted), duct end is accurately cut to length and a trumpet is secured to the cut end of the duct using a slotless joiner.

DATA RACK, FRONT TO BACK DUCT FOR FIBRE CORDS, WITH ELBOW OUTLETS

Part Number: TC1279-536KIT

This 1RU kit is installed from the front to the rear of an equipment rack, allowing fibre cords to be fed from front to back of the rack. The duct is supported by two sturdy metal mounting brackets fitted to the front and rear equipment mounting rails (4 x mounting screws and cage nuts are supplied).  The mounting brackets hold duct securing (“C”) brackets, which have a little adjustment. A short length of 30mm x 30mm duct carries the cords. One end of the duct is slotted to accept a 900 down elbow, secured by a standard joiner. The other slotted duct end accepts a 90o horizontal  LH or RH elbow.

RACK TOP, DUCT FEEDING KIT, FOR A 1 METRE EQUIPMENT RACK

Part Number: PGTC1279-751KIT

The Duct Kit fits to a 1 metre deep Equipment Rack, and enables optical fibre cords to be fed from the front to rear of rack, either LHS or RHS. Mounting brackets and screws provided

MOUNTING CLIP FOR METAL DUCTING FOR AN OVER THE TOP OUTLET

Part Number: TC1279-307S-2 

A pair of plastic mounting clips, enables an “Over the Top Outlet” to be located anywhere along a metal duct run. This enables optical fibre cords to leave the duct run at any position along its length, whilst maintaining the MBR at 30mm. The “Over the Top Outlet” allows 2.0mm dia optical fibre cords to “drop-off” the duct run and feed into 100mm x 100mm (FR) plastic duct and components. The “Over the Top Outlet” is Part No: TC1279-307A; and is available separately.

ELBOW, 90 degrees, M50 X 1.5

Data Rack Ducting & Accessories
See more

ELBOW, 90 degrees, M50 X 1.5

Part Number: TC1279-434 

This 90o Elbow is typically used to feed an optical fibre cable into a cabinet, after the cable has “broken-out” into several optical fibres. The Elbow is fastened to the cabinet using an M50 nut, after passing through a clearance hole. The lower end of the Elbow can accept either a 38mm dia cable ; or a Convoluted Tube, which houses the incoming optical fibre cable. The inner radius of the Elbow is 56mm, and the internal diameter is 41.5mm; so the Elbow can typically accept a cable of around 37/38mm dia

Looking for a tailored solution? Call us today.